Reset Start Diagnostics
65
LAUNCH
AutoDetect and manual diagnosis are supported. If the AutoDetect
fails, you can choose to input the VIN manually or exit the AutoDetect
session to switch to manual diagnosis mode.
Tap “Diagnose”*
Start decoding vehicle VIN
Decoding OK
Decoding failed
Double check vehicle info.
Select vehicle manufacturer
Tap “Reset”
Scan all vehicle systems
Select vehicle make
Choose the desired reset function
(e.g. oil lamp reset)
Select the reset mode
(Varies from vehicle to vehicle)
Output diagnostic report
Select test system
Select the desired car brand
Select diagnostic function
Follow the on-screen instructions
to proceed
Diagnostic Flowchart Manual Diagnosis Flowchart
*If you are fresh to vehicle
diagnostics, you are suggested
to use "DEMO" to get familiar
with the diagnostic process.
Input the VIN, and tap "OK", the system will automatically identify
the vehicle model. If the vehicle VIN is successfully decoded, it will
perform auto-diagnosis until a diagnostic report is automatically
output.
*Note: The most recognizable location for VIN is in the top left corner on
the vehicle's dashboard. Other locations include the driver's door or post,
and the firewall under the hood.
*Note: If "Automatic detection on connect" in "Settings" is set as ON, this
step can be ignored.
In addition to amazing & powerful diagnostic function, it also features
Oil Lamp Reset, Steering Angle Sensor Reset, Electronic Parking
Brake, Battery Maintenance System Reset, Diesel Particulate Filter,
Electronic Throttle Position Reset and ABS bleeding.
Follow the flowchart shown as below to perform it.
If you have any questions or comments please forward them to:
overseas.service@cnlaunch.com
+86 755 8455 7891
EN
To Next Page
Loading...
Need help?
General
