Launch X-431 GDS User Manual

LAUNCH X-431 GDS Batterybox Manual
Precaution on Operation
z The appliance is a sophisticated electronic device, never have it clashed
when in use.
z Main unit screen may flash at the moment of engine ignition, which is
normal.
z You may unplug the main unit if the program can not be actuated or
confused screen occurs. Plug again to continue the operation.
z Make sure the appliance is properly connected to the DLC to avoid
communication interruptions.
z During operation, keep the screen upward and leveled.
z Be careful when plugging and unplugging the main cable and diagnostic
connector. Tighten the screw before operation to avoid unexpected
disconnecting and/or damage to the port.
z Handle with care. Avoid collision. Unplug the power after operation.
z Unplug the power cable by holding the connector, not the cable itself.

Launch X-431 GDS Specifications

General

Brand	Launch
Model	X-431 GDS
Category	Battery Pack
Language	English

Summary

Precaution on Operation

Foreword

Product Summary

Summarizes the X-431 GDS, its advanced battery testing function, technology, and supported standards.

Scope of Battery Testing

Defines the purpose of battery testing, specifying the types of batteries and standards it covers for analysis.

Capability Standards for Battery Test

Details the rated capacity ranges for various battery test standards like CCA, DIN, EN, and JIS.

Test Environment and Structure

Test Environment Modes

Explains the two testing modes: 'Inside the Vehicle' and 'Outside the Vehicle', detailing their operational implications.

Battery Status Interpretation

Lists and describes the five possible states of a battery as determined by the test results.

Batterybox Hardware Structure

Describes the physical structure and key components of the Batterybox unit.

Batterybox Test Accessories

Identifies and describes the Kelvin clip and A/B cable accessories used with the Batterybox.

Connections & Operations

Device Connection Procedure

Details how to connect the batterybox to the GDS main unit using the A/B cable for communication.

Inside Vehicle Test Overview

Outlines the procedure for performing battery tests when the vehicle is connected and running.

Battery Test (Inside Vehicle)

Step-by-step guide to initiate and conduct the battery test within the vehicle environment.

Charging and Starting System Test

Procedure for testing the vehicle's charging and starting systems after the initial battery test.

Outside Vehicle Test Procedure

Procedure for testing the battery when it is disconnected from the vehicle's electrical system.

Review Software Version

Instructions for accessing and viewing the software version information of the device.

Precaution Items on Battery Test