LAVAZZA LF900 - Beverage Flow, Temperature, and Capsule Issues

38
EN
N° Problem encountered Possible causes Solution Result
12
Warning lights / ON
flashing and FREE DOSING
button ON with steady
light.
1 - Machine overheated
(internally).
Turn the machine off and
disconnect it from power mains,
wait for machine cooling down
(approx. 15 minutes). Connect
the machine to power mains,
press the MULTIFUNCTION
button.
Ok: call solved.
Non-ok: machine being serviced.
13
Warning lights / ON
flashing and FREE DOSING
button ON with light
flashing.
1 - Machine damaged, flash
error.
Power cycle the machine.
Ok: call solved.
Non-ok: machine being serviced.
14
Supply buttons / /
ON with light flashing fast.
1 - Machine damaged,
overheating error.
Power cycle the machine.
Ok: call solved.
Non-ok: machine being serviced.
15
Buttons / / /
ON, light blinks quickly for
5 seconds as the beverage is
supplied.
1 - Credit lower than the min.
limit value.
Contact Lavazza Customer
Service.
Ok: call solved.
Non-ok: machine being serviced.
16
Buttons / / /
ON, light blinks quickly for 5
seconds.
1 - Credit used up.
Contact Lavazza Customer
Service.
Ok: call solved.
Non-ok: machine being serviced.
17
The coffee flows out too fast
and no creamy froth forms on
the surface
1 - Capsule not compatible.
Use Lavazza capsules or
compatibles.
Ok: call solved.
Non-ok: go to step 2
2 - Capsule already used.
Bring the lever back to rest
position and load a new capsule.
Ok: call solved.
Non-ok: machine being serviced.
18 The coffee is cold.
1 - Coffee pours out in drops,
water circuit clogged.
Run the machine washing cycle.
Ok: call solved.
Non-ok: go to step 2
2 - The machine has
limescale build-up
Descale the machine.
Ok: call solved.
Non-ok: machine being serviced.
19
Dispensed coffee is insufficient
or excessive.
1 - Incorrect dose
programming.
Program the coffee dose
properly
Ok: call solved.
Non-ok: go to step 2
2 - Coffee pours out in drops,
water circuit clogged.
Run the machine washing cycle.
Ok: call solved.
Non-ok: go to step 3
3 - The machine has limescale
build-up.
Descale the machine.
Ok: call solved.
Non-ok: machine being serviced.
TROUBLESHOOTING