Lavor LMX 1211 XP - User Manual

Questions and Answers

M
Mark CrossAug 9, 2025
What to do if my Lavor LMX 1211 XP Pressure Washer won't start?
- P
  Patricia HernandezAug 9, 2025
  If your Lavor Pressure Washer doesn't start when switched on, there are several possible reasons. First, ensure the plug is correctly inserted into the power socket. Check if the electrical socket is working. Also, the main voltage might be insufficient, so have the mains system checked for suitability. The pump could be stuck; try turning the switch to ON while pressing the nozzle trigger. If it still doesn't work, contact an authorized service center. Finally, the gauge of the extension lead might not be sufficient.
A
Amy CastroAug 19, 2025
Why is my Lavor Pressure Washer not reaching full pressure?
- L
  Lance VangAug 19, 2025
  If your Lavor Pressure Washer isn't reaching the necessary pressure, several factors could be responsible. The filter or water inlet filter might be dirty, so remove and clean them. Extreme water temperature can also cause this issue; ensure the temperature is under 50°. Check that the delivery rate is 30% higher than the value stated on the appliance’s technical data plate. The pressure regulator valve might be set too low; increase the pressure by screwing in the pressure regulator knob. Also, the nozzle could be worn out, requiring replacement.
L
Laura LevyAug 29, 2025
What to do if my Lavor LMX 1211 XP motor stops suddenly?
- A
  Amanda MillsAug 29, 2025
  If the motor of your Lavor Pressure Washer stops suddenly, it could be due to the thermic safety switch tripping because of overheating. Let the motor cool down for a few minutes. If the problem continues, contact an authorized service center. Also, the cable extension might be inadequate.