LawnMaster CLGT2425 - Replacement Parts; Technical Data

15
GB
Replacement parts
Please indicate the machine type and the
number of the spare part with your order.
Cutting inserts...........................
Battery ......................................
Battery charger .........................
If further spare parts should be necessary,
drawing.
Technical data
Appliance
Motor voltage .............................24 V
Capacity ...................................... 1.3 Ah
Idling speed ................10300 min
-1
(rpm)
Protection Class ................................. III
Runtime ..............................max. 30 min
Cutting circle ................................25 cm
Weight .........................................2.8 kg
Sound pressure level
(L
pA
) ....................... 70.3 dB (A)
Sound power level (L
wA
)
guaranteed............................96 dB(A)
measured ...... 90.3 dB(A); K
=3.2 dB(A)
Vibration (a
n
) ..........................................
upper handle .............................2.0 m/s
2
additional handle .......................2.5 m/s
2
Battery (Li-on)
Nominal voltage .........................24 V
Capacity ...................................... 1.3 Ah
Charging time ................... approx. 3-5 h
Recharger
Uptake voltage ........ 100-240V~50/60Hz
Nominal consumption....................13 W
Voltage output ............................24 V
Recharging curren.........................0.5 A
Protection class ..............................
II
Protection category ........................
........................
IP20
* The actual runtime under load of a fully char-
ged battery depends on how you work and on
the load put on the trimmer during operation.
Noise and vibration values have been de-
termined according to the standards and
regulations mentioned in the declaration
of conformity.
Technical and optical changes may be
undertaken in the course of further de-
velopment without notice. All dimensions,
references and information in this instruc-
tion manual are therefore not guaranteed.
Legal claims made on the basis of the
instruction manual can therefore not be
considered as valid.