11
GB
Leave all work not described in this
manual to an authorised customer
service centre. Only use original parts.
Wear ear and eye protection
Sharpening, turning or replacing
the blades
Wear hand protection
• When feeding branches into the unit, keep
holding them firmly until they are automatically
drawn in.
• Adapt to the speed of the shredder and avoid
overloading the unit.
• To avoid the unit clogging up, mix freshly cut
branches or leafy material with with drier
materials such as twigs
• To prevent the blades from becoming blunt
quickly, remove mud and stones from the roots
before shredding.
• Do not shred but directly compost all soft and
wet material such as kitchen waste.
• Keep a couple of dry branches to use them for
cleaning the unit at the end.
• Do not turn off the unit until all the material
has passed the blades. Remaining material
may otherwise block the blade when you restart
the unit.
Freeing up a jam
wait until the blade comes to a standstill. Take care.
Risk of injury from electric shock, fire and rotating
blades.
• Check that the power plug ( A 7) is removed
from the mains supply.
• Unscrew the housing interlock (9).
• Tip forward the front part of the shredder housing.
You can remove it completely and put it aside.
• You now have full access to the blade (19).
• Use a screwdriver to block the blade plate (17).
Slot the screwdriver into the access hole (20)
and carefully turn the blade plate (17) until one
of the two blocking apertures appears.
Now block the blade plate (17) by slotting the
screwdriver right through it.
• Use the Allen wrench (16) to unscrew the screw
(18) in the blade plate (17) and remove the
blade (19).
Maintenance and cleaning
Before starting to service or clean the unit,
turn off the unit, pull the power plug, and
Wear hand protection when working on
the blade.
Do not spray water onto the shredder.
Electric shock hazard.
Before starting to service or clean the unit,
turn off the unit, pull the power plug, and
wait until the blade stands still. Risk of injury from
electric shock, fire and rotating blades.
General cleaning and servicing
• Always keep the shredder, wheels and air vents
clean. Use a brush or cloth to clean it, avoid
cleaners and solvents.
• Always check that the shredder and especially
the guards are not worn down or damaged but
firmly attached before use.
Before starting to service or clean the unit,
turn off the unit, pull the power plug, and
wait until the blade comes to a standstill.
Take care. Risk of injury from electric shock, fire
and rotating blades.
• Check that the power plug (7) is removed from
the mains supply.
• Unscrew the housing interlock (9).
• Tip forward the front part of the shredder
housing. You can remove it completely and
put it aside.
• You now have full access to the blades (19).
• Remove the blockage.
To Next Page
Loading...