7
GB
properly secured and that guards and
screens are in place. Replace damaged or
unreadable labels;
Operation
1) before starting the machine, look into the
feeding chamber to make certain that it is
empty;
2) keep your face and body away from the feed
intake opening;
3) do not allow hands or any other part of the
body or clothing inside the feeding chamber,
discharge chute, or near any moving part;
4) keep proper balance and footing at all times.
Do not overreach. Never stand at a higher
level than the base of the machine when
feeding material into it;
5) always stand clear of the discharge zone
when operating this machine;
6) when feeding material into the machine be
extremely careful that pieces of metal, rocks,
bottles, cans or other foreign objects are not
included;
7) if the cutting mechanism strikes any foreign
objects or if the machine should start making
any unusual noise or vibration, switch off
the machine and allow the machine to stop.
Disconnect the plug from supply and take
the following steps:
— inspect for damage;
— check for and tighten any loose parts;
— have any damaged parts replaced or
repaired with parts having equivalent
specifications.
8) do not allow processed material to build up
in the discharge zone; this may prevent
proper discharge and can result in kickback
of material through the feed intake opening;
9) if the machine becomes clogged at the inlet
opening or discharge chute switch off the
machine and disconnect the plug from supply
before clearing debris in the inlet opening or
discharge chute.
10) keep all guards and deflectors in place and
in good working condition;
11) do not transport this machine while the
machine is running;
12) switch off the machine and disconnect the
plug from supply whenever you leave the
work area;
13) do not tilt the machine while the machine is
running.
Maintenance and storage
1) when the machine is stopped for servicing,
inspection, or storage, or to change an
accessory, switch off the machine, disconnect
the plug from the supply, make sure that all
moving parts have come to a complete stop
and, where a key is fitted remove the key.
Allow the machine to cool before making any
inspections, adjustments, etc.
2) Always allow the machine to cool before storing;
Additional safety instructions for units with
bagging attachments
1) switch off the machine before attaching or
removing the bag.
Working with the device:
1) This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or
lack of experience and knowledge, unless
they have been given supervision or instruction
concerning use of the appliance by a person
responsible for their safety. Children should
be supervised to ensure that they do not play
with the appliance.
• Never use the shredder with other persons or
animals nearby.
• Wear appropriate protective clothing such as
protective gloves, firm footwear and long
trousers. Do not wear loosely fitting clothes or
clothes with dangling cords or belts.
• Only use replacement parts and accessories
To Next Page
Loading...