LawnMaster GVB1316 - Overload Protection; Changing the Cylinder

18
CHANGING THE CYLINDER
The tool has two easily exchangeable work cylinders: a dethatcher cylinder made of hard plastic with
vertically rotating spring tines, and a scarier cylinder with vertically mounted high-grade steel knives.
■ Turn the tool over.
■ Release the mounting bolt and fold the bearing cover away (Fig.13).
■ Tilt the cylinder upwards and pull the shaft out of its seat. Pulling the shaft out of its seat may require
some force initially.
WARNING
WARNING
Switch off the tool, disconnect the mains plug and wait until the cylinder is standing still.
Always wear gloves when handling the cylinder.
Fig. 13
Bearing
Cover
Mounting
Bolt
Scarier
Cylinder
OPERATION
This product is equipped with overload protection function, and it will be activated in the following
circumstances:
1. If the cutting device is wrapped by a build-up of debris.
2. If the material scaried is larger than the motor capacity.
3. Where there is too much resistance against the cutting device.
When the circuit breaker has been activated, switch off the product and disconnect it from the power
supply. Let the product cool down and clear the problem before restarting.
Overload Protection