23
TROUBLESHOOTING
The mower cuts grass unevenly
or motor labours.
The lawn is rough or uneven or
cutting height not set properly.
Adjust the cutting position to the
height best suited for your lawn.
The blade is blunt. Replace the blade.
The blade area is blocked.
Clean the blade area and
remove the blockage.
The blade is assembled
incorrectly.
Install the blade correctly. Blade
wings should be facing up away
from the ground.
Poor collection performance.
The mowing conditions are not
optimal.
Cut long grass down in stages
by gradually lowering the height
of cut. Wait for wet grass to dry.
Mulching plug is inside
collection chute.
Remove mulching plug.
The blade fails to rotate.
The blade is blocked by grass. Remove the grass.
The blade screw is loose. Tighten the blade screw.
The mower vibrates at higher
speed.
The blade screw is loose. Tighten the blade screw.
The blade is damaged. Replace the blade.
The motor shaft is bent.
Stop the motor, disconnect the
power source, and inspect for
damage. Have repaired made
To Next Page