22
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
Handles are not in position.
The carriage bolts are not
seated properly.
Adjust the height of the handle
and make sure the carriage
bolts are seated properly.
The wing knobs are not
tightened.
Tighten the wing knobs by
rotating clockwise.
The mower does not start.
The power is off.
Check the socket, fuse, cable,
wire and plug and have any
electrician.
The power cord is not
connected to power source.
Connect the power cord to a
power source.
Tripped circuit breaker in the
house.
Reset house circuit breaker.
electrician.
Defective switch lever or safety
button.
The grass is too long. Set a higher cutting height.
Jammed blade.
Stop the mower and disconnect
from the power supply, then
remove the blockage.
The motor stops.
The mower is blocked by
foreign object.
Remove the foreign object.
Motor protection has engaged
due to overheating.
Allow the mower to cool down.
Cut long grass down in stages
and avoid overloading the
motor.
Only perform the steps described within these instructions! All further inspection, maintenance and
Gloves and appropriate protective clothing must be worn when performing these instructions.
Always turn off the machine and disconnect the plug and wait until the blade stops before making
any adjustment.
WARNING
To Next Page