LawnMaster NPTBL31AB - Troubleshooting Common Issues

33
TROUBLESHOOTING
If your blower does not appear to operate properly, follow the instructions below. If this does
not solve the problem, please contact your local repair agent.
WARNING
Before proceeding, shut off the engine, wait for all moving parts to stop, and remove the battery
pack. Wait until the surfaces cool down. Failure to follow these instructions can result in serious
personal injury or property damage.
PROBLEM POSSIBLE CAUSE SOLUTION
The engine does not
start.
The battery is not
secure.
Insert the battery correctly. Ensure the battery is
fully charged.
No spark.
Clean or replace the spark plug. Reset the
spark plug gap. Refer to the Spark Plug
Replacement section in this manual.
No fuel.
Check that there is sufcient fuel in the fuel
tank. Push the primer bulb until the bulb is
full of fuel. If the bulb does not ll, the primary
fuel delivery system is blocked. Contact an
authorized service dealer. If the primer bulb lls,
the engine may be ooded, proceed to the next
item.
The engine is ooded.
Remove the spark plug referring to the Spark
Plug Replacement section in this manual. Press
the start button 5 to 10 times. Place the blower
to the side for 30 minutes with the spark plug
removed. After 30 minutes, replace the spark
plug referring to the Spark Plug Replacement
section. Then re-start the engine. If the engine
still does not start, contact an authorized service
dealer.
The air lter is blocked.
Clean the air lter. Refer to Cleaning the Air
Filter section in this manual.