8
SYMBOLS
Some of the following symbols may be used on this product. Please study them and
learn their meaning. Proper interpretation of these symbols will allow you to operate the
product better and safer.
SYMBOL NAME DESIGNATION/EXPLANATION
V Volts Voltage
A Amperes Current
Hz Hertz Frequency(cycles per second)
W Watt Power
hrs Hours Time
n
0
No Load Speed Rational speed, at no load
/min Per Minute
Revolution, strokes, surface speed, orbits etc, per
minute
Alternating Current Type of current
Direct Current Type or a characteristic of current
Lithium-Ion Battery
Recycling
Designates that this tool is in compliance with
Lithium-Ion battery recycling program requirements.
Safety Alert Indicates a potential personal injury hazard.
Read The Operator’s
Manual
You must read the operating instructions carefully.
Eye and Hearing
Protection
Always wear eye protection with side shields marked
to comply with ANSI Z87.1 along with hearing
protection when operating this equipment.
Gasoline and Lubricant
Use unleaded gasoline intended for motor vehicle
use with an octane rating of 87 [(R + M) / 2] or higher.
This product is powered by a 2-cycle engine and
requires pre-mixing gasoline and 2-cycle lubricant.
Hot Surface
Taking care to avoid coming into contact with a hot
surface.
Warning; Flammable
Material
Taking care to avoid causing a re by igniting
ammable material.
START Start Press the start button.
Close Close the choke.
To Next Page
Loading...
Need help?
General
