17
ASSEMBLY
When the robotic mower detects that there is no grass or encounters an obstacle, it changes route
in a random manner and starts mowing again in a new direction. To allow the robotic mower to
move freely inside the lawn, the lawn must be properly checked and adjusted so that the robotic
area.
Paving
The lawn requires a paved or wooden edge of at least 35 cm wide for it to stop safely and change
direction.
Raised barrier
the border of the working area.
If an existing barrier is shorter than 6 cm, replace or raise the barrier or add additional paving
Hedging
NOTE:
must be always kept on when using hedges as the border of the working area.
Fine gravel
NOTE:
blade damage.
Physical Bump Barriers
A border that physically obstructs the movement of the mower can also be used. This boundary
could be lower than 6 cm so undetectable by the ultrasonic object sensors, and also narrower than
35 cm. When the robot meets this physical barrier, it will bump off, reverse and turn. This type of
boundary may suit your lawn in some areas.
Temporary Physical Bump Barriers
To Next Page
Loading...
