LawnMaster VBRM16 - Robotic Lawnmower Assembly; Prepare the Mowing Area; Define the Mowing Area

16
ASSEMBLY
Preparation
Prepare the Mowing Area (See Figs. 1-2)
Lawn Surface
operation of the mower. Clear leaves at regular intervals and repair dead patches with grass
seed.
pools of water on the lawn and to prevent mower from becoming stuck. The mower may be
NOTE: This mower is not designed to cut excessively long or overgrown and neglected areas.
For best performance mow or trim grass down to 60mm before use. Do not allow grass to grow
excessively long between uses.
(See Figs. 3-12)
function properly.
very effective.
The robotic mower is equipped with the following devices which allow it to detect the edges and
paving.
cm. They are turned
on by default setting and will sense plants, shrubs and other obstacles in and around the edges
of the lawn. For a consistent cut, long grass must be cut down before mowing, or the ultrasonic
sensors must be turned off.
The ultrasonic sensors can be turned off when the lawn to be mowed is clear of obstacles. In this
case, hedges, walls, or other similar barriers in the lawn can be used as the border of the working
area.