LD ANNY 10 - Page 21

21
SYSTEM SETTINGS (SETTINGS)
Press the rotary-push encoder to enter the main menu and then select the SETTINGS menu item by
turning the encoder (dark background). Press the encoder again to enter the submenu and select the
desired submenu item by turning the encoder. Confirm by pressing the encoder. Refer to the following
table for information on the submenu items. Select •MAIN MENU in the submenu and press the encoder
to return to the main menu, select •HOME in the main menu, confirm by pressing the encoder, and then
return to the main display. After about 10 seconds of inactivity, the main display is automatically shown.
SETTINGS (Change value or status = turn encoder, confirm value or status change = press encoder)
LCD DIM Display illumination is switched off after approx. 10s without input ON
Display illumination permanently switched on OFF
BRIGHTNESS Adjust the display brightness from 0 – 100% 0 – 100%
CONTRAST Adjust the contrast from 0 – 100% 0 – 100%
INFO Display of the model name and the unit software version MODEL: ANNY 10
SOFTWARE: 1.x
FACTORY DEFAULT Reset to factory default settings: RESET -> SURE? -> YES
Cancel procedure: 1. CANCEL
2. RESET -> SURE? -> CANCEL
DEUTSCHFRANCAIS
ESPAÑOL
ENGLISH
ITALIANO POLSKI