27
r) Never pick up or carry a lawnmower while the engine is running.
s) Stop the engine and disconnect the spark plug wire, make sure that all moving parts have
come to a complete stop and, where a key is fitted remove the key:
— Before clearing blockages or unclogging chute;
— Before checking, cleaning or working on the lawnmower;
— After striking a foreign object. Inspect the lawnmower for damage and make repairs
before restarting and operating the lawnmower;
— If lawnmower starts to vibrate abnormally (check immediately).
t) Stop the engine and disconnect the spark plug wire, make sure that all moving parts have
come to a complete stop and, where a key is fitted remove the key:
— Whenever you leave the lawnmower;
— Before refueling.
u) Reduce the throttle setting during engine shut down and, if the engine is provided with a
shut-off valve, turn the fuel off at the conclusion of mowing.
v) Go slow when using a trailing .
4.4 Maintenance and storage
a) Keep all nuts, bolts and screws tight to be sure the machine is in safe working condition.
b) Never store the machine with petrol in the tank inside a building where fumes can reach an
open flame or spark.
c) Allow the engine to cool before storing in any enclosure.
d) To reduce the fire hazard, keep the engine, silencer, battery compartment and petrol
storage area free of grass, leaves, or excessive grease.
e) Check the grass catcher frequently for wear or deterioration.
f) Replace worn or damaged parts for safety.
g) If the fuel tank has to be drained, this should be done outdoors
5. INTENDED USE
This lawn mower has been designed for cutting grass. Any other use is not permitted.
The lawn mower is suitable for private use in the garden only, lawn mowers for private use are
those which are used for cutting grass and lawns in the garden, however not for cutting grass in
public parks, playing fields or on farms or in forest.
6. PREPARATION
6.1 Assembling lawn mower
1) Fit the lower handle on the machine with lower handle fixer bolts and nuts as per below
picture. First, release bolts, and then fit the lower handle on the brackets, last ensure that
bolts are tightened enough. Note the bolts should be fixed as fig.1 and on both sides with
the spanners.
To Next Page
Loading...