37
Fig.20 Fig.21
9. TROUBLESHOOTING
Before performing any maintenance or cleaning work, always turn off the engine and wait until
the cutter has come to a standstill
Problem Probable causes Solution
1. Engine does not
start
1.1. Not enou
h fuel in fuel tank 1.1. Add fuel
1.2. Spark plug is wet 1.2. Dry spark plug
1.3. Spark plug is damaged 1.3. Replace spark plug
1.4. Spark plug connector lose 1.4. Attach properly
2. Engine stops 2.1. Not enough fuel in fuel tank 2.1. Add fuel
2.2. Cutting device is blocked 2.2. Remove blockage
3. Unsatisfactory
result
3.1Cutting device dull 3.1Sharpen or replace the cutting
device
3.2 Height of grass exceeds
capacity
3.2Only cut grass to the capacity
of the product
3.3 Cutting height is incorrect 3.3Adjust cutting height
4.Excessive
vibration/noise or
exhaust
4.1. Cutting device is
dull/damaged
4.1. Replace with a new one
4.2. Bolts/nuts are loose 4.2. Tighten bolts/nuts
4.3. Petrol/oil is incorrect 4.3. Empty out unused petrol/oil
and refill with the correct
petrol/oil
10. STORING
Transporting the machine in a car, please empty the fuel and oil tanks completely first to avoid
the leakage.
Store the machine, operating instructions and the accessories in the original packaging. In this
way you will always have all the information and parts ready at hand. Pack the machine well or
use the original packaging in order to avoid transit damage.Store the machine in dry and well
ventilated surroundings and with the oil tank empty. Do not store oil next to the machine.
To Next Page
Loading...
