12
Maintenance schedule
12 hours of use 24hours of use 36hours of use
Air filter clean clean replace
Spark plug check clean replace
Expert inspection is required:
a) If the brush cutter strikes an object.
b) If the motor stops suddenly
c) If the blade is bent (do not align!)
d) If the gears are damaged.
Replacing and resharpening the cutting blade at the end of the mowing season always
resharpen the cutting blade or, if required, replace the cutting blade with a new one. Always
have the cutting blade resharpened or replaced by a customer service centre (measurement
of imbalance).
Unbalanced blades will cause the lawn mower to vibrate violently-risk of accident!
Change and clean the spark plug
1) Once the engine has cooled, remove the spark plug using the socket spanner supplied.
2) Clean the plug with a wire brush.
3) Using a feeler gauge; set the gap to 0.6-0.7 mm.
4) Install the spark plug carefully by hand, to avoid cross-threading.
5) After the spark plug is seated, tighten with spanner to compress the washer.
Clean the air filter
Unclip the air filter cover and remove the sponge filter element. To avoid objects falling into
the air tank, replace the air filter cover. Wash the filter element in warm soap water, rinse and
allow drying naturally.
Warning!
Never run the engine without the air filter element installed.
Storing the unit
After cutting, clean the unit thoroughly. Store the unit in a dry room allow the motor to cool
To Next Page
Loading...
