13
down beforehand.
TROUBLESHOOTING
Before performing any maintenance or cleaning work, always turn off the engine and
wait until the cutter has come to a standstill
1) Engine does not run:
---Reassemble the blade or Nylon cutter.
---check the fuel weather use out or not.
2) Engine power drops:
---Have cutting blade resharpened /replaced (customer service centre)
3) If the temperature of machines is too high:
---insure the machines have rest at regular time.
Faults which cannot be rectified with the aid of this table may be rectified by a specialist
company only (customer service centre).
To Next Page
Loading...
