11
8. If use Nylon cutter, before cutting, need bump to feed line on hardness area
9. If meet any problems, press the engine switch＂Ｏ＂, the machine will stop running. If
need stop cutting head working, release the throttle lever.
10. If meet any problem, pull the pin of safety belt, then release the brush cutter soon.
11. If the machine is hot, the throttle level can be adjusted to ON position directly when re
start the machine.
MAINTENANCE AND CARE
Before performing any maintenance or cleaning work, Always turn off the engine.
1. Do not spray the unit with water. Ingress of water may damage the engine and electrical
connection.
2. Clean the unit with a cloth, hand brush, etc.
１
To Next Page
Loading...
