Leadshine DM Series - Parallel Connections; Matching Stepper Motors

Digital Stepper Drive Hardware Installation Manual
configuration has the most inductance, the performance will start to degrade at higher speeds. In series mode, the motors should also be
run at only 70% of their rated current to prevent over heating.
Parallel Connections
An 8 lead motor in a parallel configuration offers a more stable, but lower torque at lower speeds. But because of the lower inductance,
there will be higher torque at higher speeds. Multiply the per phase (or unipolar) current rating by 1.96, or the bipolar current rating by
1.4, to determine the peak output current.
NEVER disconnect or connect the motor while the power source is energized.
Matching Stepper Motors
Minimum Motor Size Typical Motor Size Maximum Motor Size Leadshine Stepper Motors
DM320C NEMA 14 NEMA 17 MEMA 17 35HS01, 39HS02, 42HS02
DM422C NEMA 14 NEMA 17 MEMA 17 35HS01, 39HS02, 42HS02, 42HS03
DM422 NEMA 14 NEMA 17 MEMA 17 35HS01, 39HS02, 42HS02, 42HS03
DM432C NEMA 17 NEMA 23 NEMA 23 42HS03, 57HS04, 57HS09
DM442 NEMA 17 NEMA 23 NEAM 23 57HS04, 57HS09, 57HS13
DM556 NEMA 23 NEMA 23 NEMA 34 57HS09, 57HS13, 57HS22
DM856 NEMA 23 NEMA 34 NEMA 34 57HS22, 86HS35, 86HS45
DM870 NEMA 23 NEMA 34 NEMA 34 86HS45, 86HS85
DM1182 NEMA 34 NEMA 43 NEMA 43 86HS85, 110HS20
DM2282 NEMA 34 NEMA 43 NEMA 43 86HS85, 110HS20
7
HWMN
‐
DM
‐
R2011060