iii
Safety Items
!
Notice
Read this manual carefully before trying to install the stepper drive into your system. The person
setup the stepper drive should have a better understanding on electronics and mechanics. Contact
Leadshine technical guys when have questions on this document.
!
Caution
Make sure the power supply voltage dose not exceed the drive’s input range. Double check the
connections and make sure the power lead polarity is correct.
!
Warning
Do not set high current to small stepper motor. It is possible that the motor will be damaged.
!
Caution
Disconnect the motor from the load if you are not sure the move direction. Adjust the axis in the
middle before trying to run the motor.
!
Warning
Never disconnect the motor lead when the power source is energized.
HWMN‐DM‐R20110603
To Next Page
Loading...
