4
BATTERY INFORMATION
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Locate the battery cover on the
bottom of the unit, use a coin or
screwdriver to loosen the screw and
open the battery cover.
3. Remove old batteries by pulling up on
one end of each battery.
4. Install 2 new AA (AM-3/LR6) batteries
following the diagram inside the battery
box. (For best performance, alkaline batteries or fully charged
Ni-MH rechargeable batteries are recommended.)
5. Replace the battery cover and tighten the screw to secure.
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or
rechargeable batteries.
• Only batteries of the same or equivalent type as recommended
are to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Dispose of batteries safely. Do not dispose of batteries in fire.
RECHARGEABLE BATTERIES
• Remove rechargeable batteries from the toy before charging.
• Rechargeable batteries are only to be charged under
adult supervision.
• Do not charge non-rechargeable batteries.
To Next Page
Loading...
Need help?
General
