LeapFrog LF925HD - Positioning the Baby Monitor

1. Slide the On/Off switch to ON
to power on your Baby Unit.
2. Press and hold until the welcome
screen appears.
Note:
• POWER LED Light
is OFF by default.
3. Power On or Off the Baby Monitor
3
4. Status Check
Once your Baby Unit and Parent unit are powered on and connected, your Parent unit
displays video from Baby Unit, and the LINK LED light turns on.
1
5. Positioning the Baby Monitor
2
Note:
To avoid interference from other electronic devices,
place your baby monitor at least 3 feet (1 meter) away
from devices such as wireless routers, microwaves, cell
phones and computers.
Caution:
The default volume of your Parent unit is level 3, and
the maximum volume is level 5. If you experience
a screeching noise from your baby monitor while
positioning:
- Make sure your Baby Unit and Parent unit are
more than 3 feet (1 meter) apart, OR
- Lower the volume of your Parent unit.
4
Press and hold
• Motorised
pan & tilt
>
<
3ft (1m)
3ft (1m)
70
25.5°C
7
0
25
.
5°
C
>
3ft (1m)
<
3ft (1m)
70
2
5.5°C
70
25.5°
C
Tip: Want to mount Baby Unit on the wall?
Visit our Online Manual to find the wall mounting tutorial video and step-by-step guide.
4
3
5
2
1