5
GETTING STARTED
BATTERY REMOVAL AND INSTALLATION
1. Make sure the unit is turned Off.
2. Find the battery cover located on the back of the unit, use a
screwdriver to loosen the screw, and then open the battery
cover.
3. Remove old batteries by pulling up on one end of each battery.
4. Install 2 new AA (AM-3/LR6) batteries following the diagram
inside the battery box. (For best performance, alkaline
batteries or fully charged Ni-MH rechargeable batteries are
recommended.)
5. Replace the battery cover and tighten the screw to secure.
To Next Page
Loading...
