4
GETTING STARTED
BATTERY REMOVAL AND INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the back of the unit. Use a
screwdriver to loosen the screw and then open the
battery cover.
3. If used batteries are present, remove these batteries from
the unit by pulling up on one end of each battery.
4. Install 2 new AA (AM-3/LR6) batteries following the
diagram inside the battery box. (For best performance,
alkaline batteries or fully charged Ni-MH rechargeable
batteries are recommended.)
5. Replace the battery cover and tighten the screw to
secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
To Next Page
Loading...
