4
INSTRUCTIONS
BATTERY REMOVAL AND INSTALLATION
1. Make sure the unit is turned Off.
2. Locate the battery cover on the back of the unit. Use a
screwdriver to loosen the screw.
3. If used batteries are present, remove these batteries from
the unit by pulling up on one end of each battery.
4. Install 2 new ‘AA’ (AM-3/LR6) batteries following the
diagram inside the battery box. (For best performance,
alkaline batteries or fully charged Ni-MH rechargeable
batteries are recommended).
5. Replace the battery cover and tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
To Next Page
Loading...
Need help?
General