Lee Precision Lee 4 - Ammunition Charging and Seating; Safety Prime Accessory Usage; Powder Charging Steps; Case Mouth Flaring

THIS STEP IS OMITTED
WITH MOST RIFLE DIES
4
FLARE CASE MOUTH
or ease o bullet installation.
Raise the ram to expand the
case neck. To increase the lare,
screw the die in deeper. Always
adjust to provide the minimum
lare needed to start the bullet.
Aer proper adjustment, tight-
en the lock ring.
5
SEAT THE BULLET on the case mouth
and guide it into the die. Follow the instructions
included with your die set or proper adjustment.
The -Hole Turret Press gives you space to install
our Lee Factory Crimp Die.
The Lee Factory Crimp die is best, as it gives actory
like eed and dependability to your reloads
.
PRO-Auto Disk Powder Measure
pictured with the auto disk riser installed (#
 sold separately ). The case actuates
the measure to automatically drop the
exact charge while expanding the case
mouth.
6
IF LOADING maximum loads, it’s good practice
to remove all traces o case lubricant with detergent
and water. This will reduce pressure against the bolt.
CHARGING THE CASE
Regardless o how you charge the case, be absolutely certain
you have the correct amount and type o powder or the bullet
you have selected.
NEVER try to seat the primer deeper aer
the powder has been added
.
Install extension tube into body as shown Thread assembly into powder
through expanding die or rile
charging die
UTILIZING
SAFETY PRIME
I you plan
on utilizing
the accessory
Saety Prime,
install Auto Disk
Riser #,
sold separately.