Lee Precision Lee 4 - Index Adjustment and Tips; Turret Index Correction; Turret Removal Method; Spent Primer Removal

Cycle the press up and down. If the turret
does not stop in the correct position—
follow these instructions.
With the ram in the down position,
place a
N
-inch wrench on the index
rod and hold in position. Now rotate the
turret into the correct position. Never use
a pliers as index rod damage will occur.
A video is also available on our website or
preorming this adjustment:
leeprecision.com/turret-press-help-videos.html
ADJUSTING THE INDEX
TF3567
Square Ratchet
TF3562 Square Index Rod
TF3566 Auto Index Clamp
FT3570
8-32
x
1
1
⁄
2
Phillips panhead
PARTS LIST FOR THE
FOUR HOLE INDEX
LEE TURRET PRESS
HELPFUL TIPS
REMOVING TURRET
The turret turns as the press ram is lowered.
This is due to the square ratchet riding on
the index rod. The square ratchet is designed
to last nearly indeinitely and resides in the
nylon housing (Auto Index Clamp) . In order to
maintain the integrity o the square ratchet,
remember to raise the ram / way up to
disengage the ratchet rom the housing, which
then allows the index rod to spin reely. It is at
this point that the Turret can be removed by
liing and turning counterclockwise.
REMOVING SPENT PRIMERS
To remove spent primers, unbolt press rom
work bench or mounting plate.
Preerred method to use a shop vacuum.
Plug one hole in the base and insert vacuum
hose in the other hole.