4. INSTALLATION INSTRUCTIONS
Tools Required
A Phillips screwdriver, a drill and a hammer
Loca ng the appliance
Your new electric lace may be installed virtually anywhere in your
home. However, when choosing a loca on, ensure that the general
instruc ons for safety are followed.
8
or best results, install out of direct sunlight, water or very damp air.
Power supply service must be installed within proximity of electric
replace prior to nishing avoiding reconstruc on.
Minimum Clearance to Combus bles
Sides............................0 inch
Floor............................0 inch
Back.............................0 inch
Top (shelf or TV)..........8 inch min
Front...........................36 inch
WARNING! Risk of Fire! Keep electrical cords, drapery, furnishings or
other combus bles at least 3 . (0.9 m) from the front of the electric
replace.
Electrical Supply Circuit Requirements
Plan the loca on of the appliance so that it will have adequate electric
power. A 15AMP, 120V/60Hz circuit is required. Add al appliances on
the same circuit as this appliance may exceed the current ra ng of that
circuit. A dedicated circuit is not required, but is preferred to prevent
circuit breaker or fuse failure.
Prepare the outlet close to the right side of appliance. Make sure the
outlet is in good condi and the plug must be plugged ghtly in the
outlet.
9
To Next Page
Loading...
