12
Pull the boat and trailer slowly out
of the water ensuring the boat
remains centered on the trailer.
Install both trailer tie downs and
remove boat plug and stow where
you will nd it next time.
Re-tighten the winch strap
In general if the boat is in the water, the boat plug should be in. If the boat is out of the water, the plug
should be out and the boat tilted up for drainage.
6. If using a travel cover make sure to remove the windscreen on single consoles for travel cover installation
or trailering.
Important: All loose items like cup holders, tables, personal belongings, cushions, seats, etc. must be
securely stowed at all times, especially for trailering . Tops and related canvas pieces must also be
stowed and secured.
5. Ensure that your outboard is in proper position for trailering. If equipped with a transom saver, follow
installation instructions below.
For further instructions on how to install a travel cover and a full stand up top, refer to page 20.
Ensure that your outboard
is properly trimmed up.
Side console windscreen
Locate transom saver
(If equipped)
and insert end into position
just below the trailer
Turn clip
Lean the rubber support
against the lower outboard
unit and trim down to apply
enough pressure as to hold
the transom saver into place.
Pop-up
Wrap the bungie cord
around lower unit just
above the propeller and
hook into place
Remove
4.
To Next Page
Loading...
Need help?
General
