What to do if the Leggett & Platt Indoor Furnishing remote illuminates but won't activate the base?
If the remote control for your Leggett & Platt Indoor Furnishing illuminates but doesn't activate the base, ensure the power cord is correctly plugged into a working, grounded outlet. It's advisable to use a grounded surge protector. Test the outlet by plugging in another appliance to confirm it's functioning correctly.
How to fix a Leggett & Platt U-232 remote control that will not illuminate?
To fix a Leggett & Platt Indoor Furnishing remote control that won't illuminate, replace the batteries.
Why won't any features of my Leggett & Platt U-232 base activate?
If no features of your Leggett & Platt Indoor Furnishing base are working, try these steps: 1. Program the remote control (refer to the Remote Control Programming section). 2. Unplug the power cord, wait 30 seconds, and plug it back in to reset the electronic components. 3. Check your electrical service breaker box to see if a circuit breaker has tripped. 4. Test the electrical outlet with another working appliance to rule out a defective surge protector or outlet.
What to do if my Leggett & Platt U-232 head or foot section won't return to flat?
If the head or foot section of your Leggett & Platt Indoor Furnishing elevates but doesn't return to the flat position: * Check for any obstructions under the base and remove them. * Ensure the head section isn't too close to the wall.
How to reduce excessive massage motor noise in my Leggett & Platt U-232 Indoor Furnishing?
If your Leggett & Platt Indoor Furnishing massage motor is excessively noisy: * Place carpet pieces or rubber caster cups under each leg or caster if the base is on a hard floor. * Elevate the head or foot section slightly with the remote to realign the lift/lower mechanisms. * Ensure the base isn't against a wall, nightstand, or other object causing vibration. * If installed on a bed frame, confirm the massage motors aren't causing the frame to vibrate.
Emphasizes using grounded surge protection and proper electrical connections for safety.
Guides through initial setup, component checks, and base assembly.
Details the process of attaching headboard brackets to the adjustable base frame.
Step-by-step guide to program one remote control to operate one base.
Instructions for programming one remote to control two bases simultaneously.
Guides to separate programmed bases for independent remote operation.
General| Category | Adjustable Bed Base |
|---|---|
| Weight Capacity | 850 lbs |
| Number of Motors | 2 |
| Adjustable Positions | Head and Foot |
| Mattress Compatibility | Latex, Hybrid |
To Next Page