How to fix LEGRAND Inform SINUS EVO when battery backup time is short?
If the battery backup time of your LEGRAND UPS is shorter than expected: * The batteries may not be fully charged. Charge them for at least 5 hours and then check the capacity. * The batteries might be defective.
Why is the LEGRAND Inform SINUS EVO UPS beeping and overloaded?
The LEGRAND UPS may be beeping twice every second because it's overloaded. This could be due to excess loads on the UPS output, or the UPS might be locked in Bypass mode after repetitive overloads, feeding connected devices directly from the mains. To resolve this, remove excess loads from the UPS output. If it's in Bypass mode, remove excess loads first, then shut down and restart the UPS.
What to do if LEGRAND Inform SINUS EVO UPS shows fault code 43?
If your LEGRAND UPS displays fault code 43, it means the UPS shut down automatically because of an overload at the output. To fix this, remove some of the connected devices to reduce the load and then restart the UPS.
What to do if LEGRAND UPS shows fault code 14?
If your LEGRAND UPS is showing fault code 14, it indicates that a short circuit has occurred at the UPS output. Check the output wiring and any connected devices to see if they are causing a short circuit.
What to do if LEGRAND Inform SINUS EVO UPS has no indication even though the mains is normal?
If your LEGRAND UPS shows no indication or alarm even when the mains power is normal: * Check that the AC input power cord is firmly connected to the mains. * Ensure the AC input power cord is correctly plugged into the AC input and not the UPS output.
General| Input Voltage | 230 V |
|---|---|
| Output Voltage | 230 V |
| Input Frequency | 50/60 Hz |
| Number of Outputs | 4 |
| Communication Ports | USB |
| Form Factor | Tower |
| Operating Temperature | 0-40 °C |
| Storage Temperature | -15-45 °C |
| Humidity | 0-95% non-condensing |
| Technology | Line-interactive |
| Output Frequency | 50/60 Hz |
Explains the functions of each button (ON/Mute, OFF/Enter, Select) on the UPS front panel.
Details the layout and information displayed on the UPS LCD panel, including voltage, load, and mode indicators.
Explains how to set up the UPS using three programmable parameters for various functions.
Details how to set the output voltage for different UPS models and voltage ranges.
Explains the different operating modes (Online, ECO, Battery, Bypass, Standby) of the UPS.
Lists fault codes, their corresponding events, and icons for troubleshooting.
Details various warning indicators, their icons, and associated alarms for user awareness.
To Next Page