Need help?Do you have a question about the LEGRAND Niky 800 and is the answer not in the manual?
General| Apparent Power | 800 VA |
|---|---|
| Active Power | 480 W |
| Technology | Line Interactive |
| Input Voltage | 230 V |
| Output Voltage | 230 V |
| Communication Ports | USB |
| Form Factor | Tower |
| Frequency | 50/60 Hz |
| Waveform | Simulated Sinewave |
| Input Voltage Range | 170-280 V |
| Input Frequency Range | 45-65 Hz |
| Operating Temperature | 0-40 °C |
| Storage Temperature | -15-45 °C |
| Humidity | 0-95% non-condensing |
| Battery Type | Sealed Lead Acid |
| Outlets | 4 |
| Typical Backup Time at Half Load | 8 min |
Ensure outlet wiring from UPS to utility does not exceed 10 metres.
Avoid disconnecting the 230V power plug during operation to maintain earthing protection.
This C2 UPS product may cause residential radio interference; additional measures may be needed.
Describes meanings of front panel LED colors and flashing patterns.
Explains the UPS's audible alerts for running status, autonomy, and faults.
Automatic self test executed on switch-on for reliable operation.
Features automatic battery testing and deep discharge protection.
Allows the UPS to be switched on in DC mode (battery operation).
Line interactive UPS with AVR for stabilized output voltage during mains fluctuations.
Automatic switch-off in case of short circuit.
Microprocessor control for battery life saving shutdown under no load.
Dedicated filter to eliminate electromagnetic radio frequency interferences.
Outlet for appliances not needing backup protection, with surge protection.
Handle batteries with care to avoid explosion; keep away from children.
Batteries must be replaced by qualified personnel and disposed of according to law.
Identifies the location and meaning of the unit's status indicator LEDs.
Locates the main power switch on the UPS unit.
Details the RJ11/RJ45 ports for surge protection of communication lines.
Shows the location of the UPS output power sockets for connected devices.
Identifies the AC power input connector and integrated fuse.
Locates the USB port for connection to a computer for monitoring and control.
To Next Page