Group 7 Data/Programming Page 106
Release R2.0 LEIBINGER JET3
15. The print job at the fifth position of the job list shall be printed twice.
Therefore the address has not to be changed for the next print-out (13). It
will be printed again with the next <PrintGo> signal.
16. Apply the address of the print job at the first position of the job list to the X4
connector (decimal=1; 10-bit binary=0000000001 (13).
17. With the next <PrintGo> signal the addressed print job will be printed.
18. The task is finished.
Basic rules for the job list type <External Job>:
Each print job is managed separately.
Each print job needs a <PrintGo> signal to be printed.
If a single print job of the <External Job> job list has to be edited, this has
to be carried out with the job editor. The print job on the list has then to be
exchanged against the revised print job. It is not possible to edit a job on the
job list directly.
<PrintGo distance>, <PrintGo repetition> and the option for <endless>
printing have to be set within the single print jobs.
An empty address will be ignored. The last addressed print job will remain in
the print storage.
The WYSIWYG preview of the main window always shows the print job that
will be printed with the next <PrintGo> signal (14).
To Next Page
Loading...
