Leibinger Jet 3 - Data Logging (Log File Management)

Group 7 Data/Programming Page 164
Release R2.0 LEIBINGER JET3
7.4.4.2 Mix only ink/sovent
With the two buttons <Mix only Ink > (1) and <Mix only Solvent > (2) only ink or
solvent can be supplied to the hydraulic circuit.
These functions allow to set the viscosity of the ink fast to a lower or higher value.
The execution of addition of the selected medium is displayed by an accordant
message (3).
With the button <Stop> (4) the particular process will be finished.
ATTENTION
By adding solvent the ink can be diluted too strong. Therefore this
function should only be carried out by qualified personnel.
Figure 77
Ink-/Solvent delivery
1 – Button <Mix only Ink>
3 – Message <Delivery …..>
2 – Button <Mix only Solvent>
4 – Button <Stop>
1
3
2
4