Group 2 Safety instructions Page 24
Release R2.0 LEIBINGER JET3
Always ground yourself and the printer to the same potential before filling
the reservoirs! Simply touch the housing of the printer to discharge the
equipment or you must stand on a grounded surface wearing ESD shoes
during filling!
Burning gases and liquids may cause severe burns. Keep sources of ignition
away from the printer!
Read the safety data sheets and the personal protective equipment rules
and regulations!
Safe handling
These products may be used only in places that are completely free from open flames and
other ignition sources. Use only spark-free tools. Electrical equipment and tools used must
comply with the ATEX Directive.
Keep product containers tightly closed during operation. Avoid vapor concentrations that
exceed the limit values specified by the employers’ liability insurence association.
Do not use pressure to empty the product container - the container is not a pressure
vessel.
The product may become statically charged. Use a grounded line to transfer from one
container to another.
An uncluttered, clean working environment and regular, safe disposal of waste materials
minimize the risk of spontaneous ignition and other fire hazards.
If the printer is ever operated in a way that allows it to print into a beaker, the beaker
must be made of conducting material and be securely connected to earth (ground), as the
electrostatic charges on the ink drops used for printing could built up an eletrostatic charge
and may cause a fire hazard.
Employees must wear antistatic footwear and clothing, and the floors must be conductive.
Avoid skin or eye contact. Do not inhale vapors and spray mists.
Absolutely observe!
Before filling the device with the consumables, measures for the
electrostatic discharge have to be made!
Highly flammable! Burning gases and liquids may cause severe burns.
Keep sources of ignition away from the printer!
Always statically discharge the printer and yourself before filling the
reservoirs! Simply touch the housing of the printer to discharge the
equipment and stand on a grounded surface wearing ESD shoes during
filling!
To Next Page
Loading...
