Group 2 Safety instructions Page 26
Release R2.0 LEIBINGER JET3
Extract of declaration of conformity
according to machinery directive (2006/42/EG), Appendix II 1.A
according to low-voltage directive (2006/95/EG)
according to EMC directive (2004/108/EG)
…complies with the provisions of the above mentioned directives –including the changes
which valid at that time of the declaration. The following harmonized standards have been
applied:
Safety of machinery – General principles for design – Risk
assessment and risk reduction
Information technology equipment – Safety;
part 1: General requirements
Ergonomics for the thermal environment – Methods for the
assessment of human responses to contact with surfaces;
Electromagnetic compatibility (EMC) – part 6-2:
Generic standards – Immunity for industrial environments
Electromagnetic compatibility (EMC) – part 6-3:
Generic standards – Emission standard for residential, com-
mercial and light-industrial environments
For that product the relevant technical documentation were compiled according to Annex
VII part A of the machinery directive, on a resended request this documents can be
transmitted to national authorities per CD.
Name and address of the person who is authorised to arrange the technical
documentation:
Volker Teufel, authorised documentation agent, Paul Leibinger GmbH & Co. KG, D-78532
Tuttlingen (Germany)
Annotation:
The device fulfills the fundamental health and safety requirements of the directive
94/9/EU, but is intended only for use outside of explosive areas. This declaration is only
valid for the components which are included in the delivery range of the manufacturer.
The installation and works which have been carried out by the customer either the
distributor as weil as it's components and modules are not the responsibility of the
manufacturer. The adherence of the valid standards and regulations of the technology are
generally the responsibility of the customer either of the distributor.
To Next Page
Loading...
