Group 5 Transport/Start up Page 36
Release R2.0 LEIBINGER JET3
5.1 Transport, storage, shipping
In order to avoid damage during transport the following instructions must be observed.
The LEIBINGER JET3 must only be transported in a standing position. It is packed in a
cardboard box with special polystyrene inserts for safe dispatch during delivery. Transport
of the device must only be made in this packing in order to avoid damage.
The printer should be only transported in an empty condition! A special
draining routine (“ServiceFunctions Hydraulic Special Functions/ Tools
Drain Routine“) is available for the draining of the device.
You will find further information in the group Data entry/Programming in
the chapter Draining routine!
Note! Storage temperatures below +5°C and above +50°C as well as storage at outside
are not admissible and can lead to damage!
Danger of explosion!
The device must not be operated in potentially explosive areas!
The installation has to be carried out according to the installation
instructions of the manufacturer!
Precautions regarding electrostatics have to be carried out!
WARNING – INSTALLATION OF THE DEVICE
The device must be installed in a well ventilated room only and must be
kept away from any source of heat, flame or sparks, e.g. radiant heater,
etc.!
Check device for damage! When determining a suitable place of setting up, the necessary
additional space requirement for the movement room of the operating and service
personnel must be taken into consideration. Solvents are processed in the device,
adequate room ventilation must be ensured!
To Next Page
Loading...
