Group 6 Operation – Settings and functions Page 86
Release R2.0 LEIBINGER JET3
6.7 Other settings and functions
6.7.1 Carry out Hardware Reset
Enables the reset of the electronic in case of error. It is placed in the electronic-
cabinet on the main board (controller board).
Reset-switch (Hardware Reset)
The hardware reset may only be performed by trained staff!
Do not use any tools for the hardware reset.
Inpropre use of sharp or metallic tools may cause short circuits or other
damages to the circuit board!
A safe way to perform a hardware reset is to unplug the printerfor a
few seconds!
To Next Page
Loading...
