S E R V I C E - D O C U M E N T A T I O N
Seite 2 von 5
4. Remove the return flow tube on the blue tube connector and connect a pice of tube on this
connector (please see the following pictures).
Put the end of this tube into an empty ink or solvent bottle and press “Next (Weiter)” to
start the routine.
5. Dependent on the filling level of the ink tank, the routine may run a few minutes.
If the level sensor of the ink tank signales “low level”, the routine runs another 120 sec.
till the message „ink tank is empty“ appears automatically and switches off this routine.
To Next Page
Loading...
