Need help?Do you have a question about the Leica DM L and is the answer not in the manual?
General| Microscope Type | Compound |
|---|---|
| Illumination | Halogen or LED |
| Focusing | Coaxial coarse and fine focusing |
| Eyepiece | 10x |
| Stage | Mechanical stage with X/Y movement |
| Condenser | Abbe condenser |
Crucial safety advice for operating the microscope and its accessories safely.
Guidelines for selecting an appropriate workplace, considering environmental factors.
Details on different built-in power supply types and their voltage settings.
Information regarding the safety fuses used in the microscope.
Details on specific condenser types required for polarization techniques.
Steps for correctly inserting and fixing the condenser into its mount.
Instructions for assembling mechanical stages on DMLB and DMLM microscopes.
Guidance on adapting tubes and intermediate systems to the microscope stand.
Details on various HC PLAN and widefield eyepieces for visual observation.
Highlights hazards like fire and glare when handling lamps.
Crucial safety measures for handling Hg and Xe lamps, including explosion risks.
Setting the aperture diaphragm for fluorescence and other techniques.
Guidelines for using immersion objectives with oil or water.
Use of immersion condensers for phase contrast and brightfield techniques.
Step-by-step guide for setting up and performing phase contrast microscopy.
Guides on darkfield setup and troubleshooting common errors.
Steps for assembling and positioning polarizers and analysers.
Instructions for attaching filter holders and using polarizers correctly.
Procedure for achieving maximum extinction position when crossing polarizers.
How to activate and use compensator plates for polarization contrast.
Specifies the condenser tops suitable for ICT work.
Steps to achieve correct polarizer crossing for optimal ICT images.
How to check and adjust condenser prisms for proper ICT alignment.
Selection of objectives and prisms suitable for ICT microscopy.
Adjusting contrast and preparing specimens for ICT imaging.
Common issues related to specimen preparation affecting ICT image quality.
Lists errors related to polarizers, prisms, condenser tops, and illumination setup.
Steps for activating the incident light source and selecting the correct path.
Guidance on adjusting the light source and reflectors for optimal imaging.
Instructions for adjusting the collector and lamp holder for LH 106 lamphousing.
Guide to focusing and aligning lamp filaments/arcs in LH 106 z housing.
How to adjust the collector to achieve homogeneous illumination for different lamp types.
Explains how to determine the micrometer value and calibrate measurement scales.
To Next Page
