Need help?Do you have a question about the Leica DM4500 P and is the answer not in the manual?
General| Brand | Leica |
|---|---|
| Model | DM4500 P |
| Category | Microscope |
| Language | English |
General safety warning: read manual carefully before assembly and operation for safe use.
Manufacturer disclaims liability for damage from misuse or non-compliance with specifications.
IVD instruments not for patient environment; adhere to EN 60601-1 if connected to medical devices.
Device built to safety regulations; user must follow manual instructions and warnings for safe operation.
Unauthorized alterations or non-Leica components void warranty and product liability.
Details specifications for CTR5000 box, ebq 100 unit, and microscope: voltage, fuses, grounding.
Details microscope delivery in two packages: stand and system, including supply unit and electronics box.
Warning: Do not connect the microscope to AC power until assembly is complete.
Specifies dust-free room, controlled temperature (15-35°C), humidity (max 80%), and avoidance of vibrations.
Electrical components must be at least 10 cm from walls and flammable substances.
Logical assembly sequence: stage, condenser, tube, eyepieces, objectives, lamps, turret.
Warning: Never install objectives before assembling the stage.
Steps for attaching specimen holder, adjusting condenser, and loosening stage clamp.
Details securing stage clamp to dovetail guide and tightening the clamp.
Guidance on screwing condenser head, inserting into holder, and connecting to stand.
Instructions for attaching tube, inserting eyepieces, and connecting motorized tubes.
Details objective receptacles, factory assignments, and closing vacant threads with dust caps.
Warning: Ensure lamp housing is disconnected from power before assembly.
Steps for inserting 12V 100W lamp, handling dust covers, and connecting housing.
Warning: Light sources pose irradiation risk; operate in closed housings and ensure power is off.
Steps for inserting bulb, handling dust covers, and connecting housing.
Guidance on opening housing, removing transport anchors, and installing burners.
Instructions for inserting lamp mount and connecting housing to external power supply.
Step-by-step guide for inserting filter/reflector cubes into turret disk, with precautions.
Instructions for fastening polarizer to condenser holder and inserting compensators.
Guidance on removing plug caps and inserting R/P, rotating, L/ICR, R/ICR polarizers.
Warning: Adjust gas discharge lamp burner immediately after power on; do not turn on power supply unit yet.
Addresses unresponsive stand, dark/uneven illumination, flickering, and lamp startup delays.
Covers issues with focusing, contrast visibility, illumination uniformity, stray light, and phase contrast.
Solutions for polarization, weak fluorescence, dark fluorescence, and display errors like flashing or 'FAIL!'
Cautionary advice for handling chemicals; prevent contact with optics and mechanical parts.
To Next Page
