Leica M - Transferring Data to a Computer

EN
219
Additional functions
4. Confirm your settings - only possible if the eighth position is
active - by pressing the
SET or INFO button.
• A further sub-menu appears, showing
Reset image
numbering?.
5. Select
Yes or No.
1
The X characters are placeholders.
Changing picture file names
1. In the main camera menu, (see p. 154/248) select
Image
numbering (page 4, SETUP section), and
2. select
Change file name in the sub-menu.
• The name of the picture file appears. The first character is
marked as ready for editing.
Positions 1-4 can be changed.
3. The numbers and letters are changed by turning the setting
dial (30) or by pressing up and down on the direction pad (31),
while you select different positions by pressing
– the
INFO button (32),
– or the
SET button (21),
– or left or right on the direction pad.
The available characters are upper case letters from
A to Z,
numbers from
0 to 9 and underscore _, and you can scroll
through them in an endless loop.
4. Confirm your settings - only possible if the fourth position is
active - by pressing the
SET or INFO button.
• The setting menu described under 2. appears again.