241
Viewfinder displays
1. Bright line frame for 50mm and 75mm
1
(example)
2. Metering field for distance setting
3. LEDs
1
(Light Emitting Diodes) for:
a. Four-digit digital display with dots above and below
Digital display:
– Display of the automatically determined shutter speed
for aperture priority A, or for counting down shutter
speeds slower than 1s
– Warning that the metering or setting ranges are
overshot or undershot using aperture priority A
– Displays the exposure compensation value (briefly
during adjustment, or for about 0.5s when exposure
metering is activated by tapping the shutter release)
– Indicates that the back-up memory is (temporarily) full
– Indicates that no memory card is loaded (Sd)
– Indicates that the memory card is full (Full)
b.
•
Dot above:
– Indication (when lit) that saved metering values are
being used
c.
•
Dot below:
– Indicates (flashing) that exposure compensation is being
used
d.
Two triangular and one circular LED:
– For manual exposure setting: Jointly used as light
balance for exposure compensation The triangular LEDs
give the direction of rotation of the aperture setting ring
and shutter speed setting dial to adjust the exposure.
– Warning of values below the metering range
e.
Flash symbol:
– Flash ready to use
– Details of flash exposure before and after the picture
1
With automatic brightness control adjusted to the ambient brightness. This
automatic control is not available for Leica M lenses with viewfinder attachments,
since they cover the brightness sensor 5 which supplies the information required
for their operation. In such cases the frame and displays always maintain a
constant brightness.
To Next Page
