How to fix low battery on Leica Roteo 20HV Measuring Instruments?
If the low battery LED is on or flashing and the head will not rotate, check, replace alkaline batteries, or charge rechargeable batteries.
What to do if H.I. alert is on and an alarm is sounding on Leica Roteo 20HV?
If the H.I. alert is active and an alarm is sounding, it means the laser has been disturbed and its elevation may have changed. To resolve this: * Press the H.I. button to stop the alert. * Check the height against a known benchmark. * After checking, press H.I. again to reset the function.
What to do if Leica Roteo 20HV laser does not turn on?
If the laser does not turn on, the issue might be related to the batteries. Check, change, or charge the batteries to see if that resolves the problem. If the problem persists, the laser requires servicing by an authorized service center.
Why Leica Measuring Instruments laser will not self-level?
The laser must be in automatic mode to self-level. In automatic mode, both the X-axis and Y-axis LEDs will blink green while leveling. If the laser is in manual mode, one or both of the X-axis or Y-axis LEDs will be red.
What to do if Leica Roteo 20HV laser beam blinks, but the unit will not self-level or rotate?
If the laser beam is blinking but the unit won't self-level or rotate, it is likely that the unit is out of its 10% self-leveling range. Check your setup and re-level the tripod if necessary. If this doesn't fix the problem, the laser needs servicing.
Why is the Leica Roteo 20HV Measuring Instruments laser’s distance reduced?
Reduced distance may be due to dirt reducing the laser's output. Clean the windows of the laser and receiver to improve the distance. If cleaning doesn't help, the laser should be returned for service.
Why elevation alert function is not working on Leica Measuring Instruments?
The elevation alert function is normally off until activated by the user. Press the H.I. button to activate the H.I. function. When turned on, the H.I. LED will flash rapidly (5 Hz), flash slowly when active, and will turn on solid with an audio alarm when an alert occurs.
What to do if top four LED's are flashing in sequence on Leica Roteo 20HV?
If the top four LEDs are flashing in sequence, it indicates that the unit cannot level. Check your setup to ensure the unit is not tipped beyond its self-leveling range and that it is placed on a stable surface.
What to do if the Leica Roteo 20HV Measuring Instruments IR Remote is not working?
To troubleshoot the IR Remote: * Check for proper operation of the remote. * Ensure that the laser is turned on. * Verify that the remote is within the usable distance. * Aim the remote more directly at the laser. * Check the remote’s battery.
How to troubleshoot Leica Roteo 20HV Measuring Instruments motorized mount if it will not move?
If the motorized mount won't move: * Check that the locking knobs are tight enough to make contact for the motor. * Tighten the locking knobs. * Remove the mount and clean the contacts.
General| Brand | Leica |
|---|---|
| Model | Roteo 20HV |
| Category | Measuring Instruments |
| Language | English |
To Next Page