Lekker X - Safe E-bike Riding on Loose Terrain; Helmet and Light Usage Guidelines; E-bike Power and Speed Regulations; Recommended E-bike Servicing Schedule

The Class Of
MANUAL LEKKER BIKES / Lekker X 19
CHAPTER 6
12. Please take care when using E-Bikes on loose terrain, the added power
from the motor can cause the bike to lose control in these situations, Please
remember to be aware of your surroundings when using an E-bike, do not
give too much attention to the screen when riding.
13. It is law in Australia to always use a helmet when riding, it is also required
in many states to use lights when riding in low visibility conditions. We also
highly recommend wearing a helmet in countries where this is not compulsory.
14. All pedelec E-bikes must be limited to 250w power output and motor
assist cannot exceed 25km/h, Lekker Bikes will not be held liable for any
aftermarket modifications to the motor or system that may have an effect on
it’s performance.
15. Lekker Bikes recommends servicing your E-bike every 4-6 months to
ensure correct working of the bicycle, by a trained mechanic, and will not be
held responsible for any misuse, incorrect fitting or assembly of the bike.
16. Do not make any changes to your electric system or fit any other products
to it aimed at increasing the power output from your e-bike. As a rule you will
shorten the service life of the system and risk damaging the Drive Unit (motor)
and the e-bike. In addition there is also the danger that you will void the
warranty of your e-bike. Furthermore, as a result of inexpert work on the
system you will jeopardise your safety and that of other road users which risks
accidents caused by manipulations, high personal liability costs and potentially
even the danger of criminal prosecution.
Battery care & general tips
for use
The Class Of
IMAGES
Battery care & general tips
for use
MANUAL LEKKER BIKES / Lekker X 20
17. To remove the battery simply turn and hold the key in the unlock
position, pull the lever on the battery and pull sideways to release.
18. To fit the battery, place the bottom of the battery in the frame and slide
the top of the battery sideways until you hear a click. To ensure it is
correctly fitted try and move it slightly from side to side. I shouldn't move if
it's correctly inserted.
17
17.1 17.2