The Class Of
MANUAL LEKKER BIKES / Lekker X 9 MANUAL LEKKER BIKES / Lekker X 10
IMAGES CHAPTER 3
Assembly of the pedals
8. For the assembly of the pedals you will need a 15mm open
ended spanner, ATTENTION: Please make sure to check the
thread direction before inserting the pedals, as fitting the
pedal to the wrong side can damage the crank arm which is
not covered under warranty!. Apply some grease or anti seize
to the pedal threads and tighten to 40-42Nm torque, PLEASE
NOTE; It is very important to tighten the pedals to the correct
torque, as by not doing so will lead to the pedals loosening
and damaging the crank arm thread, which is not covered
under warranty!
Chapter 2
8
7
6
6.1
5.4
8.1
8.2
To Next Page
Loading...
