Pag. 6
PLEASE NOTE:
The use of normal tap water is recommended. In order to clean the boiler and remove limestone,
rinse it internally (every 15-20 litres of water used or every month) with tap water.
TECHNICAL DATA:
Adjustable iron thermostat set from 60ºC to 215ºC
Bimetallic safety iron thermostat with manual reset at 275ºC
Heating element:800W (Version 230V: 50Hz / Version 120V: 60Hz)
Boiler power : 1000W (Version 230V: 50Hz / Version 120V: 60Hz)
Working pressure: 2,5 bar
Max. pressure: 5,5 bar
Tank nominal capacity: 1,4 litres
TROUBLESHOOTING:
PROBLEM
CAUSE
SOLUTION
Does steam go
out from the
boiler?
Does the steam
iron leak steam
mixed with
It may happen that, while
filling the tank, some water
spills over the cap and flows
inside the boiler wetting the
insulating material
While filling the tank you may
have poured too much water
into it.
In order to solve the problem, we suggest using
the machine as usual so to dry up the insulating
material through the heat of the machine. In
case you still have this problem after one
working hour, please contact the service shop
The problem will go on until the excess water is
emptied. Keep the steam button depressed until
the water in the tank is at the correct level.
water?
The iron plate has to be hot
before the steam passage
Please check that the temperature knob is on
the right position: “cotton ººº)”
Does not the iron
The iron button might be off
Push the iron button the red le comes on; wait
for 4 minutes so that the iron plate warms
Push the boiler button the red led comes on:
give off steam?
Does the ironing
board wet?
Does the iron
leak dirty water?
The boiler button might be off
The water might be used up
(the low water light indicator
might be on)
The ironing board cover might
not be able to absorb the
steam completely
The steam iron leaks steam
mixed with water (check by
spraying some steam on a dry
cloth)
Maybe there is some dirty
water might have gone into
the tank and it is given off
from the iron.
wait for 10 minutes so the boiler produces
steam.
Fill it to the required level following the
instructions carefully.
You might use a thicker cover (or two covers) so
to create a thicker surface to absorb the steam
better. In case you are using a vacuum table,
switch on the vacuum function each time you
are using the steam
See # 2
Fill the empty tank with 1 liter of water, screw
the cap up, shake it, open the cap and empty
the tank. Repeat the action until the water is
cleaned. We do not recommend the use of any
additive to pour in the tank. Before ironing again
spray some steam on a cloth until clean steam
comes out.
English
To Next Page
Loading...
