To navigate through the menus
The following controls are used to move about the menu tree to
choose and select the required settings:
Select – (pressing the Select control button) this selects the
currently displayed option, if the option has a further sub-menu the
first option of the sub-menu is displayed. If the option is a setting
value, the displayed value is selected and either the next setting is
highlighted or, if there are no further settings, the display returns to
the parent menu for that setting.
Select control button – cycles forwards and backwards through the
current menu or setting options.
Back – jumps back to the parent menu of the currently displayed
menu or setting.
Menu to return to the Now Playing screen.
6.1 Equalizer
This presents a My Equaliser option to allow you to create your own
equaliser settings.
My EQ… | Normal | Classic | Jazz | Pop | Rock | Speech
6.1.1 My EQ setup…
This option allows you to set a bias in the treble and bass audio
frequencies and turn 'Loudness' On or Off. Values can be set
between -7 (Minus 7) and +7 (plus 7).
Treble – (Use the select control button to choose a bias value
between -7 and +7)
Bass – (Use the select control button to choose a bias value
between -7 and +7)
Loudness – No or Yes. (When Yes, low-level high and low frequency
sounds are boosted to give a ‘fuller' sound.)
6.2 Time/Date
The time and date can be updated manually or automatically With
auto-update, the time and date are automatically synchronised with
national time signals broadcast over DAB and FM (when available).
You can also select the display format for the time and date.
The Time menu contains the following options:
• Set Time/Date – (see below)
• Auto update - Update from Any | Update from digital radio | Update
from FM | No Update
• Set 12/24 hour - 12 | 24
• Set date format - DD-MM-YYYY | MM-DD-YYYY.
Set time/date
This option is for manually setting the time and date displayed.The
time displays as hh:mm, with the first value, hh, active (flashing).
Adjust each value using the select control button and press Select to
confirm. The next value then becomes active and flashes. The date
values follow and are set in the same way.
Note: The date displays as DD-MM-YYYY or MM-DD-YYYY
depending on your choice of date format (see above).
6.3 Backlight
The DR3 has a backlight with three brightness settings, and
adjustable timeout (this is the time delay, in seconds, after which the
display switches to the Dim level).
There are three settings:
• Timeout - Light On | 10 | 20 | 30 | 45 | 60 | 90 | 120 | 180 sec
• On level - High | Mid | Low
• Dim level - High | Mid | Low
1615
To Next Page
Loading...
Need help?
General
